Demolition Correspondence - Laserfiche WebLink

Home Browse Search

SALEM COURTHOUSE SQUARE INC. SECTION 01502 DEMOLITION TE1I~PORARY FACILITIES 1997 AND CONTROLS PAGE 3 OF 7 G. A fire safety plan shall be prepared, prior to any demolition, detailing all fire safety measures which will be addressed during the demolition. The plan shall be provided to the Owner or Owner's Representative for review and comment. A weekly status report shall also be provided during the entire demolition detailing the status of each measure. H. All temporary heating equipment shall be installed in accordance with requirements of applicable NFPA Standards and manufacturers' instructions. I. All flammable liquids shall be handled, stored and used in accordance with NFPA Standard No. 30 - 1993. J. Temporary electrical wiring and equipment used for construction: Installed and used in accordance with NFPA Standard No. 70 - 1996. K. Maintain fire department and emergency service vehicle access to site at all times. Clear building demolition areas of unnecessary obstructions so that all portions are accessible for fire department apparatus and permit emergency egress of demolition and other personnel. L. All necessary precautions shall be taken by the contractor to prevent accidental activation of all existing smoke detectors by minimizing the amount of dust generated in the vicinity of any smoke detectors until deactivated. M. All demolition activities not already covered above shall be in accordance with the latest edition of NFPA No. 241- 1993 Standard for Safeguarding Construction, Alteration, and Demolition Operations, in effect at time of contract award. 1. Penetrations through fire rated bamers shall be sealed immediately with a fire stop barrier. N. The contractor shall assign an authorized supervisory representative to issued hot work permits. Before any cutting or welding is conducted, the contractor or sub-contractors shall obtain permission from the contractor's authorized representative by the issuance of this permit. All hot work shall be conducted safely in accordance with National Fire Protection Association Standard No. S1B, Fire Prevention in the Use and Cutting and Welding Process, 1994 edition. The attached sample permit format or a similar one shall be used.