DWELL - 1616240 - Laserfiche WebLink

Home Browse Search

DATE/TIME TYPE OCCUPANCY CONST TYPE UGB: DT SITE: DWELLING PERMIT 08/24/99 16:40 New Single Family Dwellin~ R-3 V-N 23. 24. 25, 26. 27. 29~ 30. 31. PERMIT NO 99-06416 STATUS ISSUED ISSUED 08/24/1999 TO EXPIRE 02/20/2000 PAGE 4 watts of incandescent light or other artificial light source rated at a minimum of 850 lumens. Interior stairs of six steps or more shall have the required lighting located in the immediate vicinity of the top and bottom of the stairs. and the required lighting shall be controlled from the top and bottom of stairs provided the artificial light source is located directly over each stair section. [Section 303.4] GUARDRAILS AND HANDRAILS shall be able to resist a single concentrated load of 200 pounds applied in any direction at any point along the top. [Table 301.4] GUARD~ILS, Porches. balconies or raised floor surfaces located more than 30 inches above the floor or grade shall have guardrails not less than 36 inches in height. Required guardrail shall have intermediate rails or ornamental closures which do not allow passage of an object 4 inches or more in diameter. Horizontal spacing between the vertical members in required gurardrails shall be a maximum of 4 inches at the nearest point between the members. [Sec. 315.3: 315.4] HANDRAILS having a minimum and maximum height of 30 inches and 38 inches, respectively, shall be provided on at least one si de of stairways of more than three risers, All re- quired handrails shall be continuous the full length of the stairs. Ends shall be returned or shall terminate in newel posts or safety terminals, Exception: Handrails may be interrupted by a newel post at a turn, and the use of a volute turnout or starting easing shall be allowed over the lowest tread, [Sec, 315,1] THE HANDGRIP PORTION of handrails shall not be less than 1 1/4 inches or more than 2 5/8 inches in cross-sectional dimension, or the shape shall provide an equivalent gripping surface. The handgrip portion shall have a smooth surface and edges shall have a minimum radius of 1/8 inch. [Section 315.2] SMOKE DETECTORS shall be installed in each sleeping room, outside of each separate sleeping area in the immediate vicinity of the bedrooms and on each additional story of the dwelling including basements. All detectors located outside sleeping rooms shall be interconnected such that the actuation of one alarm will actuate these alarms in the individual unit and shall provide an alarm which will be audible in all sleeping areas, Smoke detectors shall be 110 volt with battery back-up. [Sec, 316,1] FIRESTOPPING shall be provided in the following locations. 1. In concealed spaces of stud walls, including furred spaces not to exceed 10 feet horizontally, and at the ceiling and floor level, 2, At all interconnections between concealed vertical and h horizontal spaces such as occur at soffits, drop or cove ceilings, etc, 3, In concealed spaces between stair stringers at the top and bottom of the run and wall cavities in line with the stringers: 4, At openings around vents, pipes, ducts, chimneys, fire- places at ceilings/floor level, w/non-combustible materials, VENT EXTENSION / ROOF, All plumbing vents, exhaust vents, and all air intakes, such as: bathroom or kitchen fans, woodstove or gas vents, air intakes, and all other such vents, shall be extended through the new roof system in an approved manner, Appropriate permits are required, HEATING APPLIANCES shall be accessible for inspection, service, repair and replacement without removing permanent construction, Unless otherwise specified, not less than 30 inches of working space and platform shall be provided in front of the control side to service the appliance. [Section 1205,1] INSTALLATION OF HEATING and cooling appliances shall conform to the conditions of their listing and label and the manu- facturer's installation instructions. The manufacturer's operating instructions shall remain attached to the appliance. Have the installation instructions available for the Mechanical Inspector at the time of inspection,