DWELL - 1529459 - Laserfiche WebLink

Home Browse Search

DATE/TIME TYPE OCCUPANCY CONST TYPE UGB: AM SITE: DWELLING PERMIT 10/26/98 15:57 New Single Family Dwelling R-2 V-N 11. 12. 14, 15. 16. 17. 18, 19, 20, PERMIT NO : 98-08282 STATUS : ISSUED ISSUED : 10/26/1998 TO EXPIRE : 04/24/1999 PAGE 2 vents restricting the airflow that is needed for good attic ventilation, BATHROOM LIGHT / VENT. Bathrooms, water closet compartments and other similar rooms shall be provided with a window of not less than 2 square feet, one half of which must be openable, or artificial light and an approved mechanical ventilation system capable of producing a change of air every 12 minutes. [Sec, 202.3] THE GARAGE shall be separated from the dwelling and its attic area by means of 1/2 inch gypsum board applied to the garage side of the wall. Where the separation is a floor- ceiling assembly, the structure supporting the separation shall be protected by 1/2 inch gypsum board or equivalent, The door between the garage and residence shall be equipped with solid weod doors not less than 1 3/8 inches in thick- ness or 20-minute fire-rated, or equivalent. [Sec, 309,1, 209.2] The sleeping rooms emergency egress windows need to provide a minimum of 20 inches in clear width and a sill height of not more than 44 inches above the finished floor elevation. Sec 310,2.1 LANDING / EXTERIOR DOOR. A minimum 3 foot x 3 foot landing shall be required on each side of an egress door, The floor or landing shall not be more than 1 and 1/2 inches lower than the top of the threshold. Exception: The landing at the exterior doorway shall not be more than 8 1/4 inches below the top of the threshold. [Sec, 212.1] SMOKE DETECTOR / POWER. In new construction, the required smoke detectors shall receive their primary power from the building wiring when such wiring is served from a commercial source, and when primary power is interrupted, shall receive power from a battery, Wiring shall be permanent and not switched. Sec. 216.2 FIRESTOPPING shall be provided in the following locations, 1. In concealed spaces of stud walls, including furred spaces not to exceed 10 feet horizontally, and at the ceiling and floor level. 2. At all interconnections between concealed vertical and h horizontal spaces such as occur at soffits, drop or cove ceilings, etc, 3. At openings around vents, pipes and ducts at ceilings and at floor levels with noncombustible materials, INSTALLATION OF HEATING and cooling appliances shall conform to the conditions of their listing and label and the manu- facturer's installation instructions. The manufacturer's operating instructions shall remain attached to the appliance. Have the installation instructions available for the Building Inspector at the time of inspection, [Section 1305.1] WATER HEATERS shall be anchored or strapped to the building to resist horizontal displacement due to eqrthquake motion. [Section 510.5 Uniform Plumbing Code] HEATING AND COOLING applicance located in a garage shall be protected from impact by automobiles, Appliances that gen- erate a glow, spark or flame capable of igniting gasoline vapors located in a garage shall be installed with burners. burner ignition devices or heating elements and switches at least 18 inches above the floor level. [Sec. 1307.3] EXTERIOR JOINTS around windows and door frames, between wall cavities and window or door frames, between wall and foundation, between wall and roof. between wall panels, at penetrations or utility services through walls, floors and roofs and all other openings in the exterior envelope shall be sealed in a manner approved by the Building Official. {E401.8.2]