DWELL - 1513495 - Laserfiche WebLink

Home Browse Search

5.BIDC00128 A'I-I'IC ACCESS. A readily accessible attic access shall be provided to any attic area having a clear height of over 30 inches. A framed opening not less than 22 inches by 30 inches is required. [Sec. 807.1] ?.BIDC0065 A GROUND COVER shall be installed on the ground in the crawl space. Ground cover shall be 6--mil black polyethylene or other approved material of equivalent perm- rating. Ground cover shall be lapped 12 inches at all joints and cover the entire surface extending full width and length of the crawl space and turn 12 inches up the foundation wall. [E 401.9.2] 8. BIDC00118 RIDGE BOARD/GUSSET. Rafters shall be framed to a ridge beard or to each other with a gusset plate as a tie. The ridge board shall be at least 1 inch nominal thickness and not less in depth than the cut end of the rafter. At all valleys and hips there shall be a valley or hip rafter not less than 2 in. nominal thickness and not less in depth than the cut end of the rafter. [Sec. 802.3] 9. BIDC00194 WATER HEATERS shall be anchored or strapped to the building to resist horizontal displacement due to earthquake motion. [Sec. 510.5 Uniform Plumbing Code] 10.BIDC00167 HANDRAILS having a minimum and maximum height of 30 inches and 38 inches, respectively, shall be provided on at least one side of stairways of more than three risers. All required handrails shall be continuous the full length of the stairs. Ends shall be returned or shall terminate in newel posts or safety terminals. Exception: Handrails may be interrupted by a newel post at a turn, and the use of a volute turnout or starting easing shall be allowed over the lowest tread. [Sec. 315.1] 11.BIDC00127 ATTIC VENTS. Provide screened attic vents with a net free area of 11150 of the attic area. (or 1/300 if between 50 and 80% of required area is ventilators in the upper portion of the attic and located at least 3 feet above eave or cornice vents. As an alternative, install a 4 mil vapor barrier on thewam~ side ofthe ceiling. [Sec. 806.2]. 12.BIDC00165 ALL INTERIOR STAIRS shall be provided with a minimum of 60 watts of incandescent light or other adificial light source rated at a minimum of 850 lumens. Interior stairs of six steps or more shall have the required lighting located in the immediate vicinity of the top and bottom of the stairs, and the required lighting shall be controlled from the top and bottom of each stair without traversing any step of the stair. Exception: An artificial light source is not required at the top and bottom of stairs provided the artificial light source is located directly over each stair section. [Sec. 303.4] 13.BIDC0101 BP. This structure uses Brace Wall Panels (BP) to meet the code requirement for lateral wall bracing. Insure that all BP's are located as indicated on the plans. 14.BIDC00148 ENCLOSED ACCESSIBLE SPACE under stairs shall have walls and soffits protected on the enclosed side with 1/2 inch gypsum board. [Sec. 310.3] 15.BIDC00140 SAFETY GLAZING/TUBS. The following shall be considered specific hazardous locations for the purposes of glazing. 1. Glazing in doors and enclosures for hot tubs, whirlpools, saunas, steam rooms, bathtubs, showers Glazing in any part of a building wall enclosing these compartments where the bottom edge of the glazing is less than 60 inches above the drain outlet)