Laserfiche WebLink
620 8TH, AUMSVILLE <br />January 28, 1995 <br /> <br />10. <br /> <br />Provide at least 1 square foot of underfloor ventilation for each 150 <br />square feet of crawl space area. The,~en~ngs s~l Re c~vered with a <br />corrosion resistant wire mesh. At ls~f~ o~ such .c~e~ing, shall be <br />provided within 3 feet of each corner*of t~e bui~nq~* ~-311 1) <br /> <br />Every sleeping room shall have at least one operable window approved for <br />emergency egress or rescue. The window sill height shall not be more <br />than 44 inches above the floor. The minimum net clear opening width <br />dimension shall be 20 inches. The mininv/m net opening height shall be <br />24 inches. The minimum net clear opening area shall he at least 5.7 <br />square feet. {R-210.2) <br /> <br />11. <br /> <br />Individual glazed areas in hazardous locations shall pass the test <br />(CPSC 16-CFR) requirements of Section R-208.3 (safety glazing). <br />Hazardous locations are considered as follows: <br />a. In doors and within 24 inches of a door. <br /> <br />12. <br /> <br />This house plan uses a combination of Brace Panels (BP) and Alternate <br />Brace Panels (ABP) to met the code requirements for lateral wall <br />bracing. Insure that all BP'S and ABP'S are located as indicated on <br />the plans and construsted as shown on the plans and the attached <br />8 1/2x11" detail sheets. <br /> <br />13. <br /> <br />THE GYPSUM BOARD BRACE PANEL SHALL BE A MINIMUM OF 4' LONG WITH ALL <br />EDGES OF THE GYP BOARD BLOCKED ON BOTH SIDES OF THE WALL. THE PA~EL <br />SHALL BE CONNECTED TO THE ROOF STRUCTURE WITH ANGLED BRACING. SEE <br />ATTACHED DETAIL SHEET. <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews or inspections <br />presuming to give authority to violate or cancel the provisions of the <br />dwelling code or of other ordinances of the jurisdiction shall not be valid. <br /> <br />DAW <br /> <br /> "APPROVED" only when this sheet is <br />attached to plans <br /> <br /> <br />