Laserfiche WebLink
• <br /> withstands subsequent pressure cycling (per ASTM E1996 and ASTM E1886) at+/- <br /> litre psf Design Pressure tested on 3/16 inch (4.7 mm) tempered glass with an applied <br /> wet glaze attachment system <br /> D. Flammability: Meets surface burning characteristics in accordance with ASTM E-84 Class A <br /> 1. Flame Spread Index= < 25 <br /> 2. Smoke Development Index= < 450 <br /> E. Volatile Organic Compound Content: <br /> 1. Compliant with the performance standard established for low-emitting materials under <br /> the CDPH, the Collaborative for High Performance Schools (CHPS) and the LEED v4 <br /> programs. <br /> 1.4 SUBMITTALS <br /> A. Submit under provisions of Section 01 30 00. <br /> B. Product Data: Manufacturer's data sheets on each product to be used, including: <br /> 1. Independent accredited testing agency reports showing compliance with specified <br /> tests in section 1,3. <br /> 2. Preparation instructions and recommendations. <br /> 3. Storage and handling requirements and recommendations. <br /> 4. Installation methods. <br /> C. Provide a Film to Glass Stress Analysis of the existing glass and proposed glass/solar film <br /> combination as recommended by the film manufacturer. <br /> D. Provide energy saving simulations report using Efilm energy analyzing software application <br /> to determine available energy cost reduction and savings. <br /> E. Shop Drawings: Detailing installation of film, anchoring accessories, and sealant. <br /> F. Verification Samples: For each finish product specified, two samples, minimum size 6 <br /> inches (150 mm) square, representing actual product, color, and patterns. <br /> G. Manufacturer's Certificates: Certify products meet or exceed specified requirements. <br /> H. Manufacturer's warranty information. <br /> 1.5 QUALITY ASSURANCE <br /> A. Manufacturer Qualifications: Products specified shall be a standard product of a <br /> manufacturer regularly engaged in the manufacturing and distribution of such products for a <br /> minimum of 10 years. <br /> 1. Provide a Quality Management certificate stating the manufacturing facility's location <br /> conformance with ISO 9001 <br /> 2. Provide an Environmental Management certificate stating the manufacturing facility's <br /> location conformance with ISO 14001 <br /> B. Installer Qualifications: Documented experience in the application of self-adhesive window <br /> films with at least 3 applications of similar size and complexity, and approved by the window <br /> film manufacturer. <br /> C. Mock-Up: Provide a mock-up for evaluation of surface preparation techniques and <br /> application workmanship. <br /> 1. Apply film and wet glaze (if required)to one window designated by Architect. <br /> 2. Do not proceed with remaining work until workmanship and color, is approved by <br /> Architect. <br /> 08 87 23-3 <br />