Laserfiche WebLink
shall be equipped with solid wood doors not less than 1 3/8 inches in thickness or 20-minute fire <br />rated, or equivalent. (R~209.2) <br /> <br />67. <br /> <br />Smoke detectors shall be installed outside of each separate sleeping area in the immediate vicinity <br />of the bedrooms and on each additional story of the dwelling including basements. In dwelling units <br />with split levels, a smoke detector need be installed only on the upper level, p~yided the lower <br />level is less than one full story below the upper level, except that if them is a door between levels <br />then a deteCtOr is required on each level. All detectors shall be intemonneeted such that the <br />actuation of one alarm will actuate all the alarms in the individual unit and shall provide an alarm <br />which will be audible in all sleeping areas. (R-215.1) <br /> <br />74. <br /> <br />Bathrooms shall be provided with artificial light and an approved mechanical ventilation system <br />capable of producing a change of air every 12 minutes or a window of not less than 3 sq. <br />one-half of which must be openable. (R-203.3) <br /> <br />78. <br /> <br />Individual glazed areas in hazardous locations shall pass the test (CPSC 16-CFR) requirements of <br /> <br />Section R-208.3, <br /> A, <br /> B, <br /> C. <br /> D. <br /> <br /> In doors and within 24 inches cfa door. <br /> Fixed and sliding panels of sliding-type doors (patio type). <br /> Glazing in storm doors. <br /> Glazing in doors and enclosures for hot tubs, whirlpools, saunas~ steam <br />rooms, bathtubs, ~howers (includes glazing in any part cfa building wall <br />enclosing these compartments where the bottom edge of the glazing is less than 60 <br />inches above the drain outlet) <br /> <br />112. Ridge board shall be at lea~t 1 inch nominal ~ickness and not less'in depth than the cut end of <br />the rafter. At all valleys and hips there shall be a valley or hip rafter not less than 2 in. nominal th/ckness <br />and not less in depth than the cut end of the rafter. (R-702.2) <br /> <br />I 0. Wood Beams, jmsts~ hender~ and studs shall not be pla~t within 2 inches fi.om the outside face of <br /> a masonry chinmey built partially or entirely, within the dwelling. Masonry chimneys built entirely <br /> outside the dwelling may be placed I inch minimum from combustible material. (R-901.13) <br /> <br />If you have questions, please contact jim Kenworthy at 371-2212. <br /> <br />Respectfully, <br />Linhart Petersen Powers Associates <br /> <br />Donald Wilson <br /> <br /> <br />