Laserfiche WebLink
8400 Silver Falls <br />November 9, 1994 <br />Page 3 <br /> <br />14. <br /> <br />rafter spans. The angle b~%~ee~ the ~lin-b~ace and a horizontal plane <br />shall be not less than 45 aegre~f T~e ~owe~ end of the purlin ~race <br />shall be supported by a load bearing wall. (R-701.1) <br /> <br />15. <br /> <br />Roof trusses are required to ~e designed by an oregon registered <br />Engineer or Architect. For trusses manufactured by an approved <br />fabrication plant, have the design and layout drawings available at the <br />construction site for the framing inspection. All job site cutting or <br />modification of the roof trusses shall be clearly shown in the <br />engineer's design calculations and drawings. If trusses are to be built <br />at the job site, submit the engineer's design and construction plans to <br />the Marion County Building Department prior to start of construction and <br />have the approved drawings available at the site for the f~amin~ <br />inspection. <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews or inspections <br />presuming to give authority to violate or cancel the provisions of the <br />dwelling code Or of other ordinances of the jurisdiction shall not be valid. <br /> <br />sf <br /> <br />"APPROVED" only when this sheet is attached to plans <br /> <br /> <br />