Permit - 1285667 - Laserfiche WebLink

Home Browse Search

Ap il 28 ~994 ~ ~ ~ - Page 2 ~o~ ~ , , The pavement of each ~cessible parking space shall be clearly marked with the international s~l ~of add~si~il'~mty to standards adopted by the Oregon Transportatic~n Com~issiq%f~ (~10~{h)l & 2) Buildings which require that toilet facilities be provided shall have at least one standard accessible facility with an accessible water closet and an accessible lavatory. Where mirrors, towel fixtures and other toilet and bathroom accessories are provided, at least one of each shall be accessible. (3108) When existing buildings and their related facilities are renovated, altered or modified, they shall have any existing architectural barriers removed in part or in total to a cost not to exceed 25 percent of the total project cost, inclusive of the cost of eliminating architectural barriers. (3112) In choosing which accessible elements to provide, priority should be given to those elements that will provide the greatest access, in the following Accessible parking. At least one accessible restroom for each sex or a single Accessible telephones. Accessible drinking fountains. and alarms. (3112) 8. The maximum slope of a ramp on an accessible route is 1 vertical to 12 horizontal. The ra~p shall be at least 36 inches in clear width. Landings shall be provide top and bottom of each run. Landings shall be level and have a minimum dimension measured in the direction of ramp run of not less than 60 inches. The maximum rise between landings for any ramp run shall be 30 inches. Handrails, as required for stairs, shall be provided on ramps having slopes steeper than i vertical to 20 horizontal. Ramps and Landings with drop-offs shall have curbs, walls or projecting surfaces that prevent people from slipping off the ramp. Curbs shall be at least 2 inches high and/or extended platforms shall be at l~ast 12 inches wide. Ramps on accessible routes shall have a slip resistance with a static coefficient of friction of 0.8. (3109(g)) 9. The underside of stair nosings shall not be abrupt. The radius of curvature at the leading edge of the tread shall be no greater than 1/2 inch. Risers shall be sloped or the underside of the nosing shall have an angle not less than 60 degrees from the horizontal. Nosings shall project no more than 1-1/2 inches. (3109(h)3 & Figure 18) Open. risers shall not be permitted. (3109(h)2) Approval of submitted plans is not an approval of omissions or oversights by this office or of noncompliance with any applicable regulations of local government. This project may be subject to the architectural standards of the Americans with Disabilities Act Of 1990 (ADA). Issuance of a building permit does not certify compliance with this Federal Statute. Copies of the guidelines and information concerning the ADA may be obtained from the Architectural and Transportation Barriers Compliance Board, 1-202-653-7834 (Voice/TDD) or 1-800 USA-ABLE. Failure to comply with the ADA may result in Federal Fines and penalties.