Laserfiche WebLink
6171 santiam Springs Ct SE <br /> Permit # 50496 <br /> Control # 93-3210 <br /> October 8, 1993 <br />· Page 1 <br /> <br />Ma, rion County <br /> OREGON <br />COMMUNITY DI~VEI.OPMi:NT <br />IDE PARTMENT <br /> <br /> Building Inspection - Dwelling Plan Review <br /> <br />The attached plans have been reviewed for compliance with the State of Oregon <br />1993 Edition one and Two Family Dwelling specialty code. <br /> <br />1. Approved numbers or addresses shall be placed on all buildings in such a <br /> position as to be plainly visible and legible from the street or road <br /> fronting the property. (UFC 10.205) <br /> <br />2. The grade away from foundation walls shall fall a minimum of 6 in. <br /> within the first 10 ft., except as restricted by lot lines where the <br /> fall will be a minimum of 6 in. regardless of the horizontal distance <br /> available. (R-301.3) <br /> <br />3. Stairways shall not be less than 3 feet in clear width and the headroom <br /> shall not be less than 6 feet 8 inches. The minimum required stair <br /> tread width is 9 inches. The maximum stair rise is $ 1/4 inches. When <br /> risers are closed, all treads may have a uniform projection not to <br /> exceed 1 1/2 inches. The greatest riser height shall not exceed the <br /> smallest by more than 3/8 inch. (R-213.1) <br /> <br />4. Handrails meeting the following requirements shall be provided on at <br /> leant one side of stairways. The handgrip portion of handrails shall be <br /> not more than 2 5/8 inches in cross-sectional dimension~ or the shape <br /> shall provide an equivalent gripping surface. Handrails shall be <br /> mounted between a minimum of 30 inches and a maximum of 38 inches. They <br /> shall be continuous the full length of the stairs. Ends shall be <br /> returned or shall terminate in newel posts or safety terminals. <br /> (R-214.1) <br /> <br /> 5. Open sides of stairs with a total rise of more than 30 inches above the <br /> floor or grade below shall have guardrails not less than 34 inches in <br /> height measured vertically from the nosing of the treads. (R-214.1) <br /> Guardrail shall have intermediate rails or ornamental closures which <br /> will not allow passage of an object 6 in. or more in diameter. <br /> Horizontal spacing between the vertical members in required guardrails <br /> shall be a maximum of 4 inches at the nearest point between the members. <br /> (R-214.2) <br /> <br /> 6. Porches, balconies or raised floor surfaces located more than 30 in. <br /> above the floor or grade shall have guardrail not less than 36 inches in <br /> height. Required guardrail shall have intermediate rails or ornamental <br /> closures which will not allow passage of an object 6 in. or more in <br /> diameter. Horizontal spacing between the vertical members in required <br /> guardrails shall be a maximum of 4 inches at the nearest point between <br /> the members. (R-214.2) <br /> <br />"APPROVED" only when this sheet is attached to plans <br /> <br /> <br />