Laserfiche WebLink
Page 2 <br /> <br />10. <br /> <br />Bathrooms shall be provided with artificial light and an approved <br />mechanical ventilation system capable of producing a change of air <br />every 12 minutes or a window of not less than 3 sq. ft., one-half <br />of which must be openable. (R-203.3) <br /> <br />Wood framed walls less than four feet in width at garage door <br />openings shall be provided with approved hold-down anchors. <br />Anchors are to be provided at each end of each wall segment and <br />oonnect the wall studding to the conorete foundation. AS an <br />alternate, a designed structural system to resist the required 80 <br />mile per hour wind load can be provided. <br /> <br />12. <br /> <br />Provide screened attic vents with a net free area of 1/150 of the <br />attic area (or 1/300 if half is along eaves and the other half in <br />the upper portion). (R-707) <br /> <br />13. <br /> <br />Energy Path #l of the Oregon Residential ~nergy Code is as <br />follows: window class U=0.40; doors, other than main entry <br />U=0.20; main entry door (maximum 24 squ. ft.) U=0.54; wall <br />insulation R-21; underfloor insulation R-25; fiat ceilings R=38; <br />vaulted ceilings R=30; skylight class U=0.50; basement walls R-21; <br />slab floor edge insulation R-15; forced air duct insulation R=8. <br /> <br />14. <br /> <br />The plans submitted do not clearly show all the required framing <br />details. It is the designer's responsibility to size all <br />structural members and fasteners for the appropriate loads and <br />then show them on the plans. Use min. No.2 DF 4x16 or 6x12 @ 16 <br />ft. opening and min. No. 2 DF 4x8 @ 9 ft. opening Or equivalent <br />sizes to support imposed loads. (R-110) <br /> <br />15. Provide proper sized pads to support ends of girder truss. <br /> <br />A soil or waste pipe passing under a footing or through a <br />foundation wall shall be provided with a pipe sleeve two pipe <br />sizes greater than the pipe passing through. (P-2003.5) <br /> <br />17. Have truss details available on jobsite for frame inspection. <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews or inspections <br />presuming to give authority to violate or cancel the provisions of the <br />dwelling code or of other ordinances of the jurisdiction shall not be valid. <br /> <br />tg <br /> <br />"APPROVED" only when this sheet is attached to plans <br /> <br /> <br />