Laserfiche WebLink
PAGE: 11 <br />11. SEAT/BACKREST ANGLES: Seat to backrest angle shall travel <br />through but not exceed five (5) degrees forward tilt and <br />fifteen (15) degrees rear tilt when measured according to <br />BIFMA CMD-1-1995 No. 7. Seatpan angle shall travel zero <br />REVISION <br />NUMBER: 002 <br />COMMODITY CODE: 42560 pA <br />NUMBER: 7119 <br />to <br />twenty <br />tilt, <br />inch <br />with <br />padded <br />shall <br />CMD-1- <br />T- <br />with <br />of <br />PRICE AGREEMENT SUMMARY <br />six (0-6) degrees, but not exceed eight (8) degrees, of <br />forward tilt. Maximum recline angle shall not exceed <br />(20) degrees rear tilt. When seat is in full forward <br />the backrest shall be not less than vertical when measured <br />according to BIFMA CMD-1-1995 No. 7. Backrest shall be <br />lockable at any point in the adjustment range and multiple <br />locked positions shall be in addition to full forward and <br />full back. Allowable tolerances: +/- 1 degree. <br />12. SEATPAN: Seatpan shall be constructed of a sealed, 5/16 <br />plywood or product of equivalent or better strength and <br />quality. The underseat mechanism shall be attached to the <br />base with four bolts and nuts; screws are not acceptable. <br />Upholstery fabric shall be securely attached to the base <br />staples. All welds shall be grounded and polished smooth. <br />All staples shall be set. Seatpan front edge shall be <br />and curved downward (waterfall edge) and the seat width <br />be a minimum of 18-1/2 inches, in accordance with BIFMA <br />1995. <br />13. ARM RESTS: Arm rests shall be height adjustable, molded <br />arms not to exceed ten (10) inches in length; installed <br />metal to metal fasteners. Travel range shall be a minimum <br />