Laserfiche WebLink
DATE/TIME <br />TYPE <br />OCCUPANCY <br />CONST TYPE <br />UGB: SITE: <br /> <br /> BUILDING PERMIT <br />08/10/98 09:57 PERMIT NO <br />Residential accessory struct STATUS <br />U-1 ISSUED <br />V-N TO EXPIRE <br /> PAGE <br /> <br />98-05278 <br />ISSUED <br />08/10/1998 <br />02/06/1999 <br /> 2 <br /> <br />PLAN REVIEW COMMENTS AND CONDITIONS <br /> <br />REQUIRED SETBACKS: Front: Left: 12 Right: 12 Rear: 12 Special: <br /> MUST BE LOCATED IN REAR YARD <br /> <br />1. CALL BEFORE YOU DIG .... IT'S THE LAW. <br /> A1-FENTION: Oregon law requires you to follow rules adopted <br /> by the Oregon Utility Notification Center. Those rules are <br /> set forth in OAR 952-001-0010 through OAR 952-001-0090. You <br /> may obtain copies of the rules by calling the center. <br /> (Note: The telephone number for the Oregon Utility Notifica- <br /> tion Center is (503) 232-1987). <br />2; THIS PLAN REVIEW WAS COMPLETED BY M. JONES ON 07/08/98. <br />3, Approval of submitted plans is not an approval of omissions <br /> or oversights by this office or of noncompliance with any <br /> applicable regulations of local government. <br />4. Approved for private non-commercial use only. <br />5, DESIGNER RESPONSIBILITY. The plans submitted do not clearly <br /> show all the required framing details. It is the designer's <br /> responsibility to size all structural members and fasteners <br /> for the appropriate loads and have them shown on the plans. <br /> [Sec. 112.1] <br />6. ENG ATTACHED. This structure uses an Engineered Design to <br /> meet the lateral wall bracing requirements of the code. <br /> Insure that all detailed construction requirements shown on <br /> the plans and on the attached engineering sheets are <br /> followed. <br />7. TRUSS DESIGN, Roof trusses are required to be be designed by <br /> an Oregon registered Engineer or Architect, For trusses <br /> manufactured by an approved fabrication plant, have the <br /> design and layout drawings available at the construction <br /> site for the framing inspection. All jobsite cutting or <br /> modifications of the roof trusses shall be clearly shown in <br /> the engineer's design calculations and drawings. <br /> <br /> <br />