Laserfiche WebLink
GW-14-A <br /> Page 4 <br /> C. Taping: Apply GacoFlex A-38 Acrylic by brush, in a 6-inch(15.24 cm)wide stripe coat,centered over all joints, <br /> penetrations and changes of plane. While coating is still wet, unroll 66B Tape onto coating and apply a coat of <br /> ( GacoFlex A-38 Acrylic over tape, smoothing out wrinkles and fish mouths. <br /> Note: On plywood,substrate taping application will require approximately 1/3 to %gallon per 100 square feet(1.25 <br /> to 1.89E/9.3 m2). <br /> Note: For a more uniform appearance,lightly sand the seam tape edges. <br /> D. First Base Coat:Apply GacoFlex A-38 Acrylic by roller in an overall coat to secure a total minimum coverage of 3/4 <br /> gallon per 100 square feet(2.84 L/9.3 m2), (Total wet film thickness -5 mils (.30 mm)). Recoat window a minimum 6 <br /> hours, but no more than 72 hours <br /> E. Second Base Goat: Apply GacoFlex A-38 Acrylic by roller to secure a total minimum coverage of%4 gallon per 100 <br /> square feet(2.84 L/9.3 m2), (Total wet film thickness-5 mils (.30 mm)). Recoat window a minimum 6 hours,but no <br /> more than 72 hours <br /> F.Third and Forth Coat and Texture:Apply two texture top coats each consisting of 3/4 gallon(2.84 L)of GacoFlex A-38 <br /> Acrylic coating and%pound or 2 cups(.34 kg) GacoShell 40/60 per 100 square feet(9.3 m2).Thoroughly blend <br /> GacoShell 40160 granules into coating before applying. <br /> Note: If not recoated within 72 hours,deck must be cleaned with GacoFlex GacoWash Concentrated Cleaner. Clean <br /> and rinse thoroughly with clean water. Do not allow the cleaning solution to dry before rinsing.Allow deck to dry <br /> completely before proceeding with coating. Drying times vary depending on weather conditions such as <br /> temperature,humidity and air movement. <br /> Note: Best results are achieved by applying texture coats in parallel overlapping roller passes/Crosshatching i.e., <br /> North-South or East-West. This will result in a pleasing uniform texture with is easy to clean.Allow 48 hours before <br /> 4.„ deck is put into use. <br /> 3.4 FIELD QUALITY CONTROL <br /> A. Thickness: The finished dry film thickness will average 21 mils (.53 mm)of acrylic elastomer and will have an <br /> approximate total thickness with GacoShell of 30 mils (.76mm). <br /> (1111/ <br /> Made in the USA • gaco.com • 800.331.0196 <br />