Laserfiche WebLink
.21 • le - OOo863@ -STtR -ot <br /> Gaco WesternFECEIVn T <br /> SINCE 1955 MAY 032019 <br /> MARION COUNTY <br /> BUILDING INSPECTION <br /> Application Specification: GW-14-A <br /> July 2016 <br /> Supersedes 04/14 <br /> DIVISION 0718 13: <br /> GACOFLEX ACRYLIC ELASTOMERIC COATING SYSTEM <br /> FOR ROLLER APPLICATION ON PLYWOOD AND CONCRETE DECKS <br /> PART 1 -GENERAL <br /> 1.1 SUMMARY <br /> This section describes the requirements for the installation of a durable, skid resistant, waterproof surface suitable for <br /> foot traffic, patio furniture, and equipment areas that are not susceptible to ponding water. <br /> Ponding water is defined as standing water in excess of 100 square feet(9.3 m2)or in excess of/:"(1.27 cm)deep <br /> or water that does not evaporate within 72 hours. <br /> This system is not intended for use over on-grade concrete. <br /> GacoFlex acrylic coatings do not have a strong odor and the wet coatings will not bum. Equipment can be easily <br /> cleaned with water and detergent. <br /> 1.2 RELATED SECTIONS <br /> A. Cast-In-Place Concrete: Division 03 30 00 <br /> B. Flashing and Sheet Metal: Division 07 60 00 <br /> C. Drains, Vents, and Penetrations: Division 07 72 00 <br /> SUBMITTALS <br /> A. Data: Submit manufacturer's standard submittal package including specification, installation instructions, and <br /> general information for each waterproofing material. <br /> B. Applicator Qualifications: Submit current"Qualified Applicator" Certificate from the specified waterproofing <br /> manufacturer. <br /> C. Americans with Disabilities Act(ADA)Recommendations: Prior to installation, submit manufacturers data indicating <br /> that the specified waterproofing application conforms to the provisions of the ADA accessibility guidelines as <br /> published by the US Access Board, 1331 F St. NW, Suite 1000,Washington, DC 20004-1111. <br /> 1.4 QUALIFICATIONS <br /> A. Primary waterproofing materials shall be product of a single manufacturer. Primary manufacturer shall recommend <br /> Ease secondary materials. Manufacturer shall have a minimum of 10 years.experience in the manufacture of materials of <br /> this type. <br /> Made in the USA • gaco.com • 800.331.0196 <br />