13001398 - Laserfiche WebLink

Home Browse Search

CORNERSTONE FOUNDATION SYSTEM LLC c140 Art Mill Lane, Roseburg,Or. 97471 (541)733-5441 PATENT NO. US. 9,109,355 BI SMART FOUNDATION RB-54,S-60 AND LS-60 INSTALLATION INSTRUCTIONS • Cut bottom of panel to height,space for wedges at bottom of panel not to exceed I". • Install top and bottom connector into precast panel. Four top and four bottom holes are cast in panel,pre drill holes when needed. Install connector plates facing outside or inside of wall panel. *Sea Poured in Place Footing Installation hi.stntctions • Install vent panels on left and right side of corner, each vent is 72 square inches.AU other panels are without vents, work from corner to center of wall or behind doorstep for last panel cut to fit. • Move panel in position with pry bar, lift snug to rim joist. Drive wedges fore,do not over tighten, may cause home to lift off of piers. "See (Wedge Set Placement • Confirm foundation wall is straight and plumb before driving screws into joist and footing, Connectors Outside of-,call-Set the face of the panel back Y"from the face of the rim joist. Drive joist screw at slight angle for maximum bite. *See Connectors Inside&Outside nil Connectors Inside of Wall -Set the face of the panel 'h"out from the face of the rim joist,basically to the face of the exterior siding. Drive joist screw at slight angle for maximum bite. *See Poured in Place Fooling Installation Instructions and Connectors Inside& Outside Will • Seal all vertical scams with caulking. Seal gap at bottom of panel to looting with non-shrink mortar. When back tilling more than 8",add moisture bather solution to mix.ALTERNATE Fool-NG PC-48 minimum 6",hack till on wall,concrete grow seal not required. • Partial precast wall panels twelve inches or wider must have two(2) top and two(2)bottom connectors. Pre drill 3116"as needed. Minimum 3" from side edge of wall panel spaced evenly. • All pier supports under the main-frame and marriage line shall be installed according to Model Manufactured Home Installation Standards and/or authorities having jurisdiction. It is the responsibility of the contractor or person(s)drawing permit to comply with Model Manufactured Home Installation Standards. Installer must comply with footing frost depth according to Model Manufactured Home Installation Standards. ATTENTION TO CONTRACTOR AND HOMEOWNER • Cornerstone Foundation System is designed to fit tight to the rim joist and sealed at the footing to prevent the entrance of rodents to the underside of home. Do not allow holes larger than '/," to he left open by installer of phone,TV cable,air conditioning lines, water gas etc. • Soil back nil -keep load of tractor away from foundation wall. Do not push against wall with tractor. j.1 ! iti .n ." 1 c s ti:in r� r r : Revised Oct.2017 d I c , t.`11 \ ✓ \ Page 10 at 13