12986627 - Laserfiche WebLink

Home Browse Search

WMMwneEpny Semigloss ODD &4/117:56AM contaminant.Repair cracks and fill voids. De-gloss shiny surfaces by lightly sanding.Clean and prime all bare metal surfaces with an appropriate primer.Prime areas as needed.Test for adhesion and compatibility with existing finishes. Disposal Never pour leftover coating down any sink or drain—use up material on the job or seal can and store safely for future use.Do not incinerate closed containers. For specific disposal or recycle guidelines,contact your local waste'management agency or district.Always attempt to recycle whenever possible. Warranty Limited Warranty:Miller Paint Company, Inc.warrants to the purchaser that this product will provide satisfactory performance when applied according to label directions. If this product does not perform to specifications,return unused portion along with sales receipt to place of purchase.As the sole remedy to purchaser,dealer will,at its option:provide additional product to correct affected areas, replace with product of equal value or refund the purchase price paid for this paint product.Failures caused by poor surface preparation,improper application or a breakdown of the underlying surface or previous paint film are not covered by this warranty. THIS WARRANTYSPEONCALLY EXCLUDES LABOR OR COST OF LABOR OR INCIDENTAL OR CONSEQUENTIAL DAMAGES ASSOCIATED WITH THE USE OF THIS PRODUCT. Possible Existing Lead Warning WARNING!If you scrape,sand,or remove old paint,you may release lead dust.LEAD IS TOXIC. ` EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS,SUCH AS BRAIN DAMAGE,ESPECIALLY IN CHILDREN.PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE.Wear a NIOSH-approved respirator to control lead exposure.Clean up carefully with a HERA vacuum and a wet mop, Before you start,find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead Product Analysis figures should be taken as accurate for products being produced at the time of publication.Formulation improvements may be made from time to time that may affect these figures to some degree.Also,manufacturing tolerances of±2%are considered acceptable. Whenever a change is made that the Manufacturer considers substantial,the Product Analysis will be revised. • • Impl/mIllerplMmeds.pleev d.n jFp Sb /p<AI.Mm Page 2 m]