Laserfiche WebLink
32S ASPEN DRIVE, SPACE 58 <br />MILL CREEK ESTATES, AUMSVILLE <br />Site %94-4629 (Permit #60180) <br />February 15, 1995 <br />Page 1 <br /> <br />Marion County <br /> <br /> OREGON <br />COMMUNITY DEVELOPMENT <br />DEPARTMI]NT <br /> <br />Building Inspection - Dwelling Plan Review <br /> <br />The attached plans have been reviewed for compliance with the State of Oregon <br />1993 Edition One and Two Family Dwelling Specialty Code. <br /> <br />This plan review covers the attachment of a prefabrica=ed carpor~ to a <br />manufactured dwelling. This review is not intended to prohibit the <br />building inspector from requesting an evaluation of the acceptability of <br />existing structural members that may appear to be unsafe. <br /> <br />The installation of the carport shall be as required by the <br />manufacturer's instruction drawings. <br /> <br />See attached letter from the Sta~e of Oregon Building Codes Division, <br />dated February 3, 1995, for the requirements of additional perimeter <br />pier blocks. <br /> <br />On Western Awning Company plan sheet no. 28, Connection Details - <br />Splices & Attachment to Building, Detail 2 specifies a #10 x 2 1/2 inch <br />lag screw at 12 inches on center (to stud wall or blocking). AS per J. <br />Byron Rupert, engineer, the attachment to the manufactured dwelling wall <br />of one lag at 12 inches on center can be revised to (2) lags at 16 inch <br />on center as to ma=ch the stud spacing of the manufactured home. See <br />attached copy of Mr. Rupert's revised fastening. <br /> <br />See attached Red Head Concrete Anchoring System for anchor size to be <br />used. <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews or inspections <br />presuming to give authority to violate or cancel the provisions of the <br />dwelling code or of other ordinances of the jurisdiction ehall not be valid. <br /> <br />MLJ <br /> <br /> "APPROVED" only when this sheet is <br />attached to plans <br /> <br /> <br />