Laserfiche WebLink
~" /~ The load carrying portion of the ground anchor shall extend <br /> belew the frost line and be at least ~2 inches above th~ water <br /> table~ <br /> <br /> [.(115.] l~) Ties, strapping or other approved methods or material <br /> shall be .... ' <br /> [~ .... ti~.] suitaDle for the ~UrDose of this rule <br /> shall meet the followlnq criteria: <br /> <br /> (a) All ties shall be fastened to ground anchors and drawn tight <br /> with turnbuckles, other adjustable tensioning devices or devices <br /> supplied with the ground anohor[+]~ <br /> <br /> [(a)] (b) Tie materials shall be capable of resisting an <br /> allowable working load of 3,'150 pounds with no more than two <br /> percent elongation and shall withstand a 50 percent overload; <br /> <br /> [~ch~] (c) Ties shall connect the ground anchor to the main <br /> structural steel frame (I-beam or equivalent) which runs lengthwise <br /> under the manufactured dwelling. Ties shall not connect to steel <br /> outrigger beams which fasten to and intersect with the main <br /> structural frame unless specifically stated in the manufactured <br /> dwelling manufacturer's installation instructions; <br /> <br /> [.(e~] ~dk In the absence of the manufacturer's installation <br /> instructions, the connection of the cable frame tie to the <br /> manufactured dwelling main structural frame member shall be by a <br /> 5/8 inch drop-forged, closed-eye bolt through a hole drilled in the <br /> upper one quarter of the main frame or other approved methods. The <br /> main frame shall be reinforced if necessary to maintain the <br /> designed strength of the mainframe; <br /> <br /> [~] (e) Cable ends shall be secured with at least three U-bolt <br /> type cable clamps with the U portion of the clamp installed on the <br /> short (dead) end of the cable to assure strength equal to that <br /> required by section (1) of this rule[~]~ <br /> <br /> if) Stra9Dinq installed on manufactured dwell.i, nqs located ~ithln <br /> 20 miles of the coast shall be stainless steel or 0.035 i.nch thick <br /> <br />and 1-l~4_~nch wide steel coated with not less than .0.30 ounces of <br /> <br />zinc ~.er foot and certified as conformlnq <br />Specification D3955-87;. <br /> <br />to ASTM Standard <br /> <br /> <br />