Laserfiche WebLink
6121 Santiam Springs Ct. S.E., Aumsville <br />August 11~ 1993 <br />Page 3 <br /> <br />19. <br /> <br />20. <br /> <br />21. <br /> <br />22. <br /> <br />Roof trusses are required to be designed by an Oregon registered <br />Engineer or Architect. For trusses manufactured by an approved <br />fabrication plant, have the design and layout drawings available at the <br />construction site for the framing inspection. All job site cutting Or <br />modification of the roof trusses shall be clearly shown in the <br />engineer's design calculations and drawings. <br /> <br />Water heaters having nonrigid water connections and over 4-feet in <br />height from the base to the top of the tank case shall be anchored or <br />strapped to the building to resist horizontal displacement due to <br />earthquake motion. (M-1006.2) <br /> <br />Factory built chimneys and venting systems shall conform to the <br />conditions of their listing and the manufacturer's installation <br />instructions. (R-902) <br /> <br />Heating appliances shall be accessible for inspection, service, repair <br />and replacement without removing permanent construction. Unless <br />otherwise specified, not less than 30 inches of working space and <br />platform shall be provided to service the appliance. (R-1106) <br /> <br />Rafters shall be provided with lateral support at points Of bearing to <br />prevent rotation. (R-702.7) <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews or inspections <br />presuming to give authority to violate or cancel the provisions of the <br />dwelling code Or Of other ordinances Of the jurisdiction shall not be valid. <br /> <br />"APPROVED" only when this sheet is attached to plans <br /> <br /> <br />