Laserfiche WebLink
655 Olney St., Aumsville <br />July 14, 1993 <br />Page 2 <br /> <br />10. <br /> <br />12. <br /> <br />Wood framed walls less than four feet in width at garage door openings <br />shall be provided with approved hold-down anchors. Anchors are to be <br />provided at each end of each wall segment and connect the wall studding <br />to the concrete foundation. As an alternate, a designed structural <br />system to resist the required 80 mile per hour wind load can be <br />provided. <br /> <br />Provide screened attic vents with a net free area of 1/150 of the attic <br />area (or 1/300 if half is along eaves and the other half in the upper <br />portion). (R-707) <br /> <br />A readily accessible attic access shall be provided to any attic area <br />having a clear height of over 30 inches. A framed opening not less than <br />22 in. by 30 in. is required. (R-708) <br /> <br />Roof trusses are required to be designed by an Oregon registered <br />Engineer or Architect. FOr trusses manufactured by an approved <br />fabrication plant, have the design and layout drawings available at the <br />construction site for the framing inspection. All job site cutting or <br />modification of the roof trusses shall be clearly shown in the <br />engineer's design calculations and drawings. <br /> <br />Water heaters having nonrigid water connections and over 4-feet in <br />height from the base to the top of the tank case shall be anchored or <br />strapped to the building to resist horizontal displacement due to <br />earthquake motion. (M-1006.2, 1320 (e)) <br /> <br />14. Please see the attached sheet for the ~nergy code requirements <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews Or inspections <br />p~esuming to give authority to violate or cancel the provisions of the <br />dwelling sode or of other ordinances of the jurisdiction shall not be valid. <br /> <br />"APPROVED" only when this sheet is attached to plans <br /> <br /> <br />