Laserfiche WebLink
S35 9th st, Aumsville <br />August 5, 1991 <br />Page 1 <br /> <br />Marion County <br /> OREGON <br />COMMUN[¥Y D£VELOPMENT <br /> <br />suildia~ Inspection - ~elling Flan Review <br /> <br />The attached plans have been reviewed for compliance with the State of Oreqon <br />1990 Edition One and Two Family Dwelling Specialty Code. <br /> <br />Foundation walls shall extend at least 8 in. above the finished grade to <br />the foundation at all points. (R-304.2) {6 in. where preaeure treated <br />sill plates are used.) <br /> <br />Provide an access crawl hole to the underfloor space. The minimum size <br />opening required is 18 inches by 24 inches. (R-309.2) <br /> <br />The garage shall be completely separated from the residence and its <br />attic area by means of 1/2-inch gypsum board or equivalent applied to <br />the garage side. The door between the garage and residence shall be <br />equipped with solid wood doors not less than 1 3/8 inches in thiskness <br />or equivalent. (R-209.2) <br /> <br />In new construction, required smoke detectors shall receive their <br />primary power from the building wiring. Smoke detectors may be battery <br />operated when installed in existing buildings. (R-215.2} <br /> <br />Wood framed walls less than four feet in width at garage door openings <br />shall be provided with approved hold-down anchors. Anchors are to be <br />provided at each end of the wall segment and connect the wall studding <br />to the concrete foundation. As an alternate, a designed structural <br />system to resist the required 80 mile per hour wind load can be <br />provided. <br /> <br />A readily accessible attic access shall be provided to any attic area <br />hawing a clear height of over 30 inches. A framed opening not less than <br />22 in. by 30 in. is required. (R-708) <br /> <br />Roof trusses are required to be designed by an Oregon registered <br />Engineer or Architect. For trusses manufactured by an approved <br />fabrication plant, have the design and layout drawings available at the <br />construction site for the framing inspection. Ail job site cutting Or <br />modification of the roof trusses shall be clearly shown in the <br />engineer's design calculations and drawings. If trusses are to be built <br />at the job site, submit the engineer's design and construction plans to <br />the Mar&on County ~uilding Department prior to start of construction and <br />have the approved drawings available at the site for the ~raming <br />inspection. <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews or inspections <br />presuming to give authority to violate or cancel the provisions of the <br />dwelling code or of other ordinances of the jurisdiction shall not be valid. <br /> <br />"APPROVED" only when this sheet is attached to plans <br /> <br /> <br />