Laserfiche WebLink
205 2nd. St., <br />June 24, 1991 <br />Page 1 <br /> <br />Aumsviile <br /> <br />Marion County <br /> OREGON <br />COMMUNITy DEVELOPMENY <br /> <br />Building Inspection - Dwelling Plan Review <br /> <br />The attached plans have been reviewed for compliance with the state of Oregon <br />1990 Edition One and Two Family Dwelling Specialty Code. <br /> <br />The minimum diameter of the holes is 24" and the minimum depth of <br />embedment of the posts is 48". A concrete floor will provide a <br />"constrained" condition for the posts. <br /> <br />Roof trusses are required to be designed by an Oregon registered <br />Engineer or Architect. For trusses manufactured by an approved <br />fabrication plant, have the design and layout drawings available at the <br />construction site for the framing inspection. Ail job site cutting or <br />modification of the roof trusses shall be clearly shown in the <br />engineer's design calculations and drawings. If trusses are to be built <br />at the job site, submit the engineer's design and construction plans to <br />the Marion County Building Department prior to start of construction and <br />have the approved drawings available at the site ~or the framing <br />inspection. <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews or inspections <br />presuming to give authority to violate or cancel the provisions of the <br />dwelling code or of other ordinances of the jurisdiction shall not be valid. <br /> <br />"APPROVED" on1¥ when this sheet is attaohed to plans <br /> <br /> <br />