Permit - 1268589 - Laserfiche WebLink

Home Browse Search

CONSTRUC'TION REQUIREMENTS (Continued): ~6~ Vent kitchen fan to outside via ~etal ducts. ~ In bathrooms, water closet compartments, laundry rooms and s~milar rooms, a mechanical ventilation system connected d~rectly to the outside, capable of five air changes per hour shall be ~rovided where there are no openable windows. OUBC 1205-a Provide all habitable rooms h'- outside windows with net areas of not less than 1/10 of floor areas sot 10 sq. ft. Every sleeping room shall have an exterior door ~or not less than 5.7 sq. ft. of openable window. The min. net clear opening aeignt shall be 24 inches. The min. net clear opening width shall be 20 inches. The finished sill height shall De not more then 44 inches. 0UBC 1204 and 1205 (a) ~ Provide at least one 36" swinging (exit) door OUBC 3304 (e) a. Max. 8" rise. Min. 9" run. O. Headroom over stairs 6'6" min. c. Handrail designed for 20 lbs. lateral load. Table 23-c d. Stairways having less than 4 risers need not have handrails. 3306 (j) ~ Heating facilities capable of ~aintaining a temperature of 68 dcgrees F. at a point 3' above the floor are required in all habitable roms. OUBC 1211 ~ Warm air furnace shall not be installed in a bedroom or bathroom. 0~4C 704 ~.~3~ Where bottom of glass light is within 18" of floor and all glass doors and wall panels of bathtub and shower enclosures, must be of laminated, tempered or wire glass. OUBC 5406 (d) 34. Approved numbers or addresses shall be provided for all new buildings ~n such a position as to be plainly visible and legible from the street or road fronting the property. p~ov Every dwelling shall be lded with an approved product of combustion detector other than heat mounted on the ceiling or wall at a point centrally located in the corridor or area giving access to sleeping rooms. Where sleeping rooms are on an upper level~ the detector shall be placed at the center of the ceiling directly above the stairs. Care shall be exercised when locating cold air return to furnace so that air flow to detector from non-sleeping areas is not impeded. A smoke detector shall be installed in the basement of dwelling un.ts ~aving a s=alrway opens from the basement Into the dwelling. Such detector shall be connected to a sounding device to provide an alarm which will be audible ~n the sleeping area. 0UBC 1210 (a) 36. Loose-fill insulation. Blown, poured and spray-on type may be used in attic spaceS where roof slope is 4 in 12 or grater and there is at least 44" of headroom at the ridge. 5303 (a) 2.A 37. Thermal insulation shall not be installed within 3" of any metal chimney or gas vent. ~, Insulation requirements. ~-u~ldings with high-efficiency heating equipment such as: 1. Heat pumps that shows a coefficient of performance as required in Table No. 53-D. Gas and oil fired that shows a minimum combustion efficiency of 80 percent Annual Fuel Use Efficiency (AFUE) rating. building elements insulated as May have Follows: Ceiling R- 3 0 (roof/ceiling assemblies zn which has a slope of 3 in 12 or greater, may be R-19). walls R-19 Floors R-19 Other Heating systems: Ceilings R~38 (roof/ceiling assemblies in which as a slope of 3 in 12 or greater may be R-19) Walls R-19 Floors R-19 OUBC 5303 (c)l 39. Slab min. 24" length of R-4.5 insulation placed between slab and foundation wall, length to include horizontal and vertical distance. 5303 (c) 4 J~ Weatherstrip doors between heated ~h~d unheated areas. 41. Heat ducts installed under floor or in attic shall be provided min. R-4.5 INSULATION. 42. R-11 perimeter ins~lation accepted when crawl space is a plenum. Draft baffles are required at eave ~7~nts to deflect ventilation air over blown insulation. (OUBC Section) 5303 2A 44. Fireplace and chimney construction shall conform to chapter 37 OUBC 45. When alterations, repairs, or additions having a valuation of $1,000.00 occur, or sleeping rooms are added ~n existing Group R, Division 3 occupancies, the entire building shall be provided with smoke detectors as specified in UBC 1210 (a) 46. Sky lights set at an angle less than 45 degree from horizontal shall be set at least 4" above the plane of roof on a curb contacted as required for the frame.