12293635 - Laserfiche WebLink

Home Browse Search

Onsite Permit 555-23-006940-PRMT Page 2 of 3 Schedule or track inspections at www.buildingpermits.oregon.gov Call or text the word "schedule" to 1-888-299-2821 use IVR Number:555088923369 Schedule using the Oregon ePermitting Inspection App, search"epermitting"in the app store ,...-,�¢�. + z � �-�� :-: +�'' r� . 'y�v, °� z'�� .�'a ^�+.�. � . •y 't�.k'�'-a`"�i,,-�'^$�v= � '��a° _ Rate[s ic! 2/16/24 4 _ s e it f iratlon da 211 /25 v to'� °.. % "aTF SA �"�s 3s � � �^ �.� tea. � a Yc�a°�`�.. �� v � ` , a 3 Wor 1d IAt 9,XkR j1�AJ F2EP 3 l S ,K, SFt3 T 9 g- s.� , +. `�;. q3,c p�:fu �' a' E m. ,„s T °* s';c � ��" �� '.P. :�.a �3`�.,°. a Conditions of approval •Filter fabric required over drain media(rapidly permeable soils). •The owner of a pressurized distribution system must maintain a contract with a certified maintenance provider to inspect, adjust and maintain the onsite system.The maintenance provider must submit an annual report and annual evaluation fee. •Dry soil installation only(June 1 —October 1 unless otherwise authorized by the agent). •The system must be installed by the property owner or a licensed sewage disposal business (installer). •Vehicular traffic and livestock must be restricted from the system area. •All roof drains must be directed away from the system -All tanks must be tested for watertightness and have a water-tight riser to the ground surface. Twenty-inch minimum diameter if less than 36-in deep.Thirty-inch minimum diameter if greater than 36-in deep. Maintain access to septic tank for pumping and service. •Meet all required setbacks •The system must be installed in the area approved during the site evaluation and in accordance with the construction plan approved by the agent, including any changes made by the agent. •All work is to conform to OAR 340, Division 71 and 73. Make no changes in system location or specifications without approval by the agent. •For product approval information and manufacturer installation requirements see DEQ website at: http://www.oregon.gov/deq/Residential/Pages/Onsite.aspx •The pump and alarm must be wired on separate circuits in the control panel.Pump wiring must comply with applicable building, electrical, or other codes.An electrical permit and inspection from the Department of Consumer and Business Services, Building Codes Division, or the municipality with jurisdiction, is required for pump wiring installation. •Install the pump and system components in accordance with the approved pump curve and specifications. •A minimum 18-gauge, green jacketed tracer wire or green color-coded metallic tape must be placed on top of the effluent sewer or pressure transport pipe from tank to drainfield. 2/15/24:2:13:47PM ONS_OnsitePermitpr