12267777 - Laserfiche WebLink

Home Browse Search

Onsite Permit 555-20-009195-PRMT Page 3 of 4 Schedule or track inspections at www.buildingpermits.oregon.gov Call or text the word "schedule" to 1-888-299-2821 use IVR Number:555070946210 Schedule using the Oregon ePermitting Inspection App, search"epermitting"in the app store Date issued 2/4/21 Expiration:date.2/4/22 Work description FIRE;MAJ REP 2.BDRM. PRIMARY Conditions of approval •Both the initial and replacement disposal areas are to be protected from traffic, livestock and farming activities, development or other potential disturbance of natural soil conditions •The pump and alarm must be wired on separate circuits in the control panel. Pump wiring must comply with applicable building, electrical, or other codes.An electrical permit and inspection from the Department of Consumer and Business Services, Building Codes Division, or the municipality with jurisdiction, is required for pump wiring installation. -Install the pump and system components in accordance with the approved pump curve and specifications. •The area must not be subjected to excessive saturation due to, but not limited to, artificial drainage of ground surfaces, roads, driveways and building down spouts. •This approval is given on the basis that the parcel described above will not be further partitioned or subdivided. •Pressurized distribution rules at OAR 340-071-0275. Install sweep elbows at ends of lateral piping with acceptable threaded plugs or caps (minimum head of 5-ft at remotest orifice, less than 10%variation). •Filter fabric required over drain media (site has rapidly draining soils). •The owner of a pressurized distribution system must maintain a contract with a certified maintenance provider to inspect, adjust and maintain the onsite system. The maintenance provider must submit an annual report and annual evaluation fee. •Dry soil installation only (June 1 —October 1 unless otherwise authorized by the agent). •The system must be installed by the property owner or a licensed sewage disposal business (installer). -All tanks must be tested for water-tightness and have a water-tight riser to the ground surface. Twenty- inch minimum diameter if less than 36-in deep (thirty-inch minimum diameter if greater than 36-in deep). •Maintain access to septic tank for,pumping and service -The system must be installed in the area approved during the site evaluation and in accordance with the construction plan approved by the agent, including any changes made by the agent. • All work is to conform to OAR 340, Division 71 and 73. Make no changes in system location or specifications without approval by the agent. •For product approval information and manufacturer installation requirements see DEQ website at: http://www.oregon.gov/deq/Residential/Pages/Onsite.aspx •A minimum 18-gauge, green jacketed tracer wire or green color-coded metallic tape must be placed on top of the effluent sewer or pressure transport pipe from tank to drainfield. •Sewage ejector(grinder) pump: septic tank must be two-compartment with an effluent filter. •Effluent sewer must extend at least 5 feet beyond the septic tank before connecting to the distribution unit. It must be installed with a minimum fall of 4 inches per 100 feet and at least 2 inches of fall from one end of the pipe to the other. In addition, there must be a minimum difference of 8 inches between the invert of the septic tank outlet and either the invert of the header to the distribution pipe of the highest lateral in a serial distribution field or the invert of the header pipe to the distribution pipes of an equal distribution absorption field 2/4/21:3:26:39PM Page 3 of 4 ONS_OnsitePermit_pr