Laserfiche WebLink
Onsite Permit 555-21-000498-PRMT Page 2 of 3 <br /> Schedule or track inspections at www.buildingpermits.oregon.gov <br /> Call or text the word "schedule" to 1-888-299-2821 use IVR Number:555085014144 <br /> Schedule using the Oregon ePermitting Inspection App, search"epermitting" in the app store <br /> Date issued:2/26/21 Expiration date:2/26/22 <br /> Work description: FIRE REPL AUTH/MAJ REPAIR REPL 3 BDRM RES <br /> Other special rqmt: use approved EZ Flow seepage trench configuration <br /> Conditions of approval <br /> •Due to the available area being limited by lot size, steep slopes, and a downslope cut, <br /> installation of a standard system cannot be approved. <br /> •Under OAR 340-071-0215, a reasonable repair will be granted and the system must be a <br /> Seepage Trench, as defined in OAR 340-071-0280. This system will require 50 feet of seepage <br /> trench.Dry soil installation only(June 1 —October 1 unless otherwise authorized by the agent). <br /> •The system must be installed by the property owner or a licensed sewage disposal business <br /> (installer). <br /> •Vehicular traffic and livestock must be restricted from the system area. <br /> -All roof drains must be directed away from the system <br /> -All tanks must be tested for watertightness and have a water-tight riser to the ground surface. <br /> Twenty- inch minimum diameter if less than 36-in deep. Thirty-inch minimum diameter if greater <br /> than 36-in deep. Maintain access to septic tank for pumping and service. <br /> Meet all required setbacks <br /> •The system must be installed in the area approved during the site evaluation and in accordance <br /> with the construction plan approved by the agent, including any changes made by the agent. <br /> •Effluent sewer. The effluent sewer must extend at least 5 feet beyond the septic tank before <br /> connecting to the distribution unit. It must be installed with a minimum fall of 4 inches per 100 feet <br /> and at least 2 inches of fall from one end of the pipe to the other. In addition, there must be a <br /> minimum difference of 8 inches between the invert of the septic tank outlet and either the invert of <br /> the header to the distribution pipe of the highest lateral in a serial distribution field or the invert of <br /> the header pipe to the distribution pipes of an equal distribution absorption field. <br /> -Each drainfield trench must be level within a tolerance of plus or minus 1-inch. <br /> .This system has been approved under OAR 340-071-215 (4)(b)allowing for a reasonable <br /> repair, and the setback and sizing standards cannot be met, compromise allows for 50 ft of <br /> seepage trench to be installed as that is all that can fit and will allow for 12 ft setback to <br /> cutbank created by previous garage installLthe current system was 30 ft or less and under <br /> where the deck was and the tank was rusted out. This parcel was involved in the Beachie <br /> Creek Fire <br /> 2/26/21:9:45:54AM Page 2 of 3 ONS_OnsitePermit_pr <br />