11990373 - Laserfiche WebLink

Home Browse Search

Onsite Permit 555-23-000912-PRMT Page 2 of 3 Schedule or track inspections at www.buildingpermits.oregon.gov Call or text the word "schedule" to 1-888-299-2821 use IVR Number:555042228854 Schedule using the Oregon ePermitting Inspection App, search"epermitting"in the app store Date issued:3/21/23 Expiration date: 3/20/24 Work description: MAJ ALT: ADD PUMP TANK FOR ACCR Media type: Other- Indicate Product/Manufacturer Media depth: N/A Media type description: EZ Flow Trench length: 220 linear ft. Rock above pipe: N/A Max depth: 36 in. Undisturbed soil between trenches: N/A Min depth: 24 in. Capping fills-min depth of fill material: N/A Special Requirements Groundwater type: Not Applicable Groundwater depth: N/A Pump to drainfield reqd: Yes Filter fabric on top of drain media: N/A Other special rqmt: Replacing 220 linear feet of drainfield underneath accessory building on the property. Effluent line and Water lines can run in the same trench persuant to OAR 340-071-0220(1)(C) Conditions of approval •Effluent lines and water lines may run in the same trench,see OAR 340-071-0220(1)(j)(C)for requirements. •An electrical permit and inspection from the Department of Consumer and Business Services, Building Codes Division,or the municipality with jurisdiction,is required for pump wiring installation. •The system must be installed by the property owner or a licensed sewage disposal business (installer). •Vehicular traffic and livestock must be restricted from the system area. •All roof drains must be directed away from the system •All tanks must be tested for watertightness and have a water-tight riser to the ground surface.Twenty-inch minimum diameter if less than 36-in deep.Thirty-inch minimum diameter if greater than 36-in deep. Maintain access to septic tank for pumping and service. •Meet all required setbacks •Install the pump and system components in accordance with the approved pump curve and specifications. •The pump and alarm must be wired on separate circuits in the control panel. Pump wiring must comply with applicable building, electrical,or other codes. •Dry soil installation only(June 1 —October 1 unless otherwise authorized by the agent). •Serial distribution,each trench bottom to be level and on contour. Use Drop box(es). •Each drainfield trench must be level within a tolerance of plus or minus 1-inch. •Header pipe from Distribution or Drop Box must be minimum 4-ft length, level,and bedded. •Maximum length of an individual trench is 150-feet. •All work is to conform to OAR 340, Division 71 and 73. Make no changes in system location or specifications without approval by the agent. •For product approval information and manufacturer installation requirements see DEQ website at: http://www.oregon.gov/deq/Residential/Pages/Onsite.aspx 3/21/23:2:27:11PM ONS_OnsitePermit_pr