11988913 - Laserfiche WebLink

Home Browse Search

Septic Permit 555-23-006639-PRMT Page 2 of 3 A F; WAR tic 0AJ JILtw • 'rT w -3' a x e. `si€ c a w't5 ^, ja. s '^xv off, s. 4t1 it n s .„, .... -�... ..... .... ..�°,wm.�,a .�,m.�.,.- �� sue,s\F.w ...,.a....:..:�.._ r .,. _ '‘flpfprgyp •This permit is a reasonable repair,it is for placing the dwelling at 15296 Woodburn-Monitor Road on a holding tank. This is considered a permanent solution to the failure unless it is demonstrated that a siting requirement can be met for a drainfield facility to serve this dwelling. •An anti-buoyancy device is required for the septic tank(s)and must be installed as per the manufacturer installation guidelines. •The alarm be set at 75%of tank volume and must be wired on separate circuits in the control panel.Alarm wiring must comply with applicable building,electrical,or other codes.An electrical permit and inspection from the Department of Consumer and Business Services,Building Codes Division,or the municipality with jurisdiction, is required for pump wiring installation. •Properly decommission the old septic tank and submit appropriate documentation. •A failing system must be repaired as soon as possible.Should the repair of this system be delayed,the property owner must notify the agent and provide the reasons for delay,and propose a different completion date.Delays may be cause for formal enforcement action,which may result in civil penalty assessments. •The system must be installed by the property owner or a licensed sewage disposal business(installer). •AII tanks must be tested for watertightness and have a water-tight riser to the ground surface.Twenty-inch minimum diameter if less than 36-in deep.Thirty-inch minimum diameter if greater than 36-in deep.Maintain access to septic tank for pumping and service. •A minimum 18-gauge,green jacketed tracer wire or green color-coded metallic tape must be placed on top of the effluent sewer or pressure transport pipe from tank to drainfield. •The system must be installed in the area approved during the site evaluation and in accordance with the construction plan approved by the agent, including any changes made by the agent. •All work is to conform to OAR 340, Division 71 and 73.Make no changes in system location or specifications without approval by the agent. •For product approval information and manufacturer installation requirements see DEQ website at: http://www.oregon.gov/deq/Residential/Pages/Onsite.aspx Installation of this onsite wastewater treatment system has been determined to comply with the applicable requirements in Oregon Administrative Rules Chapter 340, Divisions 071 and 073 and the Conditions of Approval above. 1. In accordance with Oregon Revised Statute 454,665,this Certificate of Satisfactory Completion is issued as evidence of satisfactory completion of an onsite wastewater treatment system at the location identified above. 2. Issuance of this Certificate does not constitute a warranty or guarantee that this onsite wastewater treatment system will function indefinitely without failure.Conditions imposed as permit requirements continue for the life of the system. 3.The area of the initial and the identified replacement area must not be subjected to activity that is likely to adversely affect the soil or the functioning of the system.Such activities may include, but are not limited to,vehicular traffic,livestock, covering the area with asphalt or concrete,filling,cutting,or other soil modification activities. 4.This onsite wastewater treatment system that be connected to the facility referenced herein within 5 years of the issuance of this Certificate of Satisfactory Completion(CSC)or rules for authorization notices,alteration permits,or construction-installation permits as outlined in OAR 340-071-0160,340-071-0205,or 340-071-0210 apply,including payment of an additional fee. 5.This system must operate in compliance with OAR Chapter 340, Division 071 and must not create a public health hazard or pollute public waters. 6.Unless otherwise required by the agent,the system installer must backfill(cover)this system within 10 days after the issuance of this Certificate of Satisfactory Completion. 12/5/23:4:45:23PM ONS_OnsiteCSC pr