11476078 - Laserfiche WebLink

Home Browse Search

Onsite Permit 555-21-008417-PRMT Page 2 of 3 Schedule or track inspections at www.buildingpermits.oregon.gov Call or text the word "schedule"to 1-888-299-2821 use IVR Number:555003231464 Schedule using the Oregon ePermitting Inspection App, search"epermitting"in the app store Date�sSued 218122 expiration date 218/23 Work BDRM REPL 3 BDRMD A Q Min depth: 18 in. Capping fills-min depth of fill material: N/A Special Requirements " Stake out required: Yes Groundwater type: Permanent Groundwater depth: N/A Pump to drainfield reqd: Yes Filter fabric on top of drain media: Yes Conditions of approval •This repair permit is for replacement of the existing septic system following the Beachie Creek Fire of 2020.A reasonable repair is granted to allow for 400 square feet of seepage bed instead of 500 square feet.The system is sized at 375 gallons per day as it is a lot of record pre-1978 and cannot accommodate a system sized for 450 gallons per day. •Properly decommission the old septic tank and submit appropriate documentation. •The system must be installed by the property owner or a licensed sewage disposal business(installer). •Vehicular traffic and livestock must be restricted from the system area. •AII tanks must be tested for watertightness and have a water-tight riser to the ground surface.Twenty-inch minimum diameter if less than 36-in deep.Thirty-inch minimum diameter if greater than 36-in deep. Maintain access to septic tank for pumping and service. •The system must be installed in the area approved during the site evaluation and in accordance with the construction plan approved by the agent, including any changes made by the agent. •The pump and alarm must be wired on separate circuits in the control panel. Pump wiring must comply with applicable building,electrical,or other codes.An electrical permit and inspection from the Department of Consumer and Business Services,Building Codes Division,or the municipality with jurisdiction, is required for pump wiring installation. •Install the pump and system components in accordance with the approved pump curve and specifications. •A minimum 18-gauge,green-jacketed tracer wire or green color-coded metallic tape must be placed on top of the effluent sewer or pressure transport pipe from tank to drainfield. 2/8/22:7:55:25AM ONS_OnsitePermitpr